Automatic transmission treatment - Automatic transmission protection

Automatic Transmission Treatment (ATT) is specially formulated to protect automatic transmissions

The product can be used for all types of automatic transmissions, however, the product cannot be used in e.g. CVT or other types of multitronic gearboxes.

Using Lindemann Automatic Transmission Treatment improves valve function. This results in smoother and faster gear changes, reduced oil waste, reduced wear and reduced noise.

In the event of oil spillage, the particles in Lindemann Automatic Transmission Treatment form an independent seal that reduces or stops oil spillage. If the damage changes, the seal changes accordingly as the particles circulate in the oil.

It is still recommended to replace the gear oil and Lindemann Automatic Transmission Treatment according to the manufacturer's recommendations, but no later than after 100,000 km.

BENEFITS

• Provides smoother gear shifting
• Reduces noise from the gearbox
• Improves valve function
• Provides unrestricted oil passage
• Extends gearbox life

DOSAGE AND INSTRUCTIONS FOR USE

1. Shake the bottle vigorously.
2. ATT is added when the engine is at normal operating temperature. ATT is poured through the dipstick tube into the gearbox. The engine must be started immediately and run at idle for at least half an hour.
3. The treatment is repeated after each major overhaul of the gearbox.
4. Engine and gearbox must be at normal operating temperature before treatment.
5. If the gearbox has not been serviced within 30,000 km or more, add ATT after the service has been performed.
6. ATT does not affect the frictional resistance on the surface of the clutch plates.
7. NOTE! ATT does not clog the gear's oil filter!
8. One bottle of ATT 300 ml. is enough for 10 liters of gearbox oil. In a gearbox where the oil content is between 10 and 20 liters of oil, 2 bottles of ATT are used.
9. Cannot be overdosed